Call 800-282-0090


Home > Data Sheet
PREMASK 4600
Pre-Mask Application Tape



General Information
PREMASK 4600 is a 5.3mil natural color transfer premask consisting of a translucent saturated paper coated with a rubber resin-based adhesive. This tape is fully compatible for plotter cuts and thermal die cuts of all sizes and vinyl lettering. Its medium tack is ideal for most transfer applications, and it features good resistance to abrasion and moisture
Backing Adhesive
(unwind)
Thickness
(total)
Liner Type
(outer)
Crepe Paper Rubber 5.30 mil  
Adhesion to Steel
180° Peel
Adhesive Activation Tensile Strength Elongation Percent
  Pressure 11.00 lbs/in 4.00%
Min Application
Temp
Min Service
Temp
Max Short-Term
Temp
Max Long-Term
Temp
40 °F      
Adhesive Tape Features
  • Good Resistance to Abrasion and Moisture
  • Medium Tack
Adhesive Tape Applications
  • Transfer Applications
  • Fully Compatible for Plotter and Thermal Die Cuts
Adhesive Tape Markets Served
  • Commercial printing
  • Commercial
Adhesive Tape Colors
  • Natural
Comparable products
Backing Adhesive Thickness Adhesion
 Crepe Paper   Rubber   5.30mil   oz/in 

The physical properties listed are typical values and are not to be considered as specifications. Our suggestions for use are based on tests we believe to be reliable. However, the purchaser must carry out their own tests to determine the suitability of the product for their internal use. Information is given in good faith, but without warranty.

It is essential, as with all pressure-sensitive tapes, that the surface to which the tape is applied be clean, dry and free of grease and oil.

Shelf life from date of manufacture is based on the product being stored at 70°F(21°C) / 50% relative humidity out of direct sunlight.

Specification compliance is dynamic and should only be used as a general guide. Always confirm that the tape you are interested in currently complies with all specification requirements. Please verify that the product number that you select is available in the proper size and color to meet your specification.


Choose the surface energy of the exact surface that the adhesive will contact (e.g. if the part was painted metal, paint would be the surface energy).