Call 800-282-0090


Home > Data Sheet
LABLPRO 4360
2mil Polypropylene Label Protection Tape



General Information
LABLPRO 4360 is a 2 mil polypropylene film coated in a solvent-based non-yellowing acrylic adhesive. This tape is used for prescription/label protection and lamination. It is UV Resistant.
Backing Adhesive
(unwind)
Thickness
(total)
Liner Type
(outer)
PP - Polypropylene Acrylic 2.00 mil  
Adhesion to Steel
180° Peel
Adhesive Activation Tensile Strength Elongation Percent
23.00 oz/in Pressure 20.00 lbs/in 140.00%
Min Application
Temp
Min Service
Temp
Max Short-Term
Temp
Max Long-Term
Temp
40 °F 32 °F 140 °F  
Adhesive Tape Features
  • Non-Yellowing Acrylic Adhesive System
  • UV Resistant
Adhesive Tape Applications
  • Prescription/Label Protection and Lamination
Adhesive Tape Markets Served
  • Commercial
  • Industrial
Adhesive Tape Colors
  • Clear
Comparable products
Backing Adhesive Thickness Adhesion
 PP - Polypropylene   Acrylic   2.00mil   23.00oz/in 
Backing Adhesive Thickness Adhesion
 Acetate   Acrylic   2.50mil   25.00oz/in 

The physical properties listed are typical values and are not to be considered as specifications. Our suggestions for use are based on tests we believe to be reliable. However, the purchaser must carry out their own tests to determine the suitability of the product for their internal use. Information is given in good faith, but without warranty.

It is essential, as with all pressure-sensitive tapes, that the surface to which the tape is applied be clean, dry and free of grease and oil.

Shelf life from date of manufacture is based on the product being stored at 70°F(21°C) / 50% relative humidity out of direct sunlight.

Specification compliance is dynamic and should only be used as a general guide. Always confirm that the tape you are interested in currently complies with all specification requirements. Please verify that the product number that you select is available in the proper size and color to meet your specification.


Choose the surface energy of the exact surface that the adhesive will contact (e.g. if the part was painted metal, paint would be the surface energy).