Low VOC Double-Coated SB Non-Woven Tape

General Information
FT 8260 Low VOC is a 7.4 mil double-coated SB non-woven tape. It is designed for applications requiring high adhesion to low surface energy materials. Specification # 56972
Backing Adhesive
Liner Type
Non-Woven Acrylic 7.40 mil 84# Natural Poly-coated Kraft
Adhesion to Steel
180° Peel
adhesion to steel 180° peel - liner side Tensile Strength Elongation Percent
95.00 oz/in 169.00 oz/in    
Min Application
Min Service
Max Short-Term
Max Long-Term
50 °F   250 °F 200 °F
Adhesive Tape Features
  • Very aggressive acrylic adhesive
  • Low fogging qualities
  • Thick double-coated, non-woven tape
  • Does not contain any of the 13 chemicals restricted by the Japanese Ministry of Health, Labor and Welfare
  • High adhesion to low surface energy plastics
  • High initial tack
  • Meets OEM fogging specifications
  • Excellent bond to foams and fabrics
Adhesive Tape Applications
  • Bonding of foams and fabrics
Adhesive Tape Markets Served
Adhesive Tape Colors
Comparable products
Backing Adhesive Thickness Adhesion
 Non-Woven   Acrylic   7.40mil   95.00oz/in 

The physical properties listed are typical values and are not to be considered as specifications. Our suggestions for use are based on tests we believe to be reliable. However, the purchaser must carry out their own tests to determine the suitability of the product for their internal use. Information is given in good faith, but without warranty.

It is essential, as with all pressure-sensitive tapes, that the surface to which the tape is applied be clean, dry and free of grease and oil.

Shelf life from date of manufacture is based on the product being stored at 70°F(21°C) / 50% relative humidity out of direct sunlight.

Specification compliance is dynamic and should only be used as a general guide. Always confirm that the tape you are interested in currently complies with all specification requirements. Please verify that the product number that you select is available in the proper size and color to meet your specification.

Choose the surface energy of the exact surface that the adhesive will contact (e.g. if the part was painted metal, paint would be the surface energy).