3M
583
Heat Bonding Film
583 is a 2 mil, rubber (nitrile/phenolic) heat activated adhesive transfer used for bonding printed circuit boards. 583 is a high strength, flexible and can be crosslinked using a post heat exposure. This crosslinking will provide additional heat and solvent resistance as well as somewhat higher shear strengths. It can be heat or solvent activated for bonding.
| Backing/Carrier | |
|---|---|
| Adhesive | Rubber |
| Thickness | 2 Mils |
| Tensile | 400.00 lbs/in |
|---|---|
| Elongation | |
| Adhesive Activation | Heat |
| Adhesion (unwind) | 160 oz/in |
| Min. Application Temp | 40° F |
|---|---|
| Min. Service Temp | 0° F |
| Max Short-Term Temp | |
| Max Long-Term Temp |
Product Features
- 2 lb. Dead Load Overlap Shear Heat Resistance before crosslinking is 160°F
- Modulus = 240psi
- Elongation = 800%
- Adhesion to stainless steel = 10 piw
- Samples were bonded on Sencorp device for 5 seconds dwell (+10 seconds ramp time) at 315°F, 20 lbs pressure
- Dielectric Constant@1 kJz =3.1
- Dielectric Breakdown Strength 3000 volts/mil (on 1.5 mil)
- Dissipation Factor @1kHz = .064
- Surface Resistivity is 3.14 x 10 to the 10th power ohms/sq.
- Flexible
- Heat or solvent activation
- Can be die-cut
- Slight surface tack
- Heat crosslink optionable
- Slight tack
Adhesive Tape Colors
- Brown
Converting Services
Precision Cutting, Die Cutting, Slitting, Printing, Laminating and Coating, Spooling and Finishing, Consulting & Process Audit, Prototyping, Inventory Management
At Budnick, we specialize in custom converting these materials into labor saving, user-friendly parts.
Data provided by Budnick Converting, Inc.
The physical properties listed are typical values and are not to be considered as specifications. Our suggestions for use are based on tests we believe to be reliable. However, the purchaser must carry out their own tests to determine the suitability of the product for their internal use. Information is given in good faith, but without warranty.
It is essential, as with all pressure-sensitive tapes, that the surface to which the tape is applied be clean, dry and free of grease and oil.
Shelf life from date of manufacture is based on the product being stored at 70°F(21°C) / 50% relative humidity out of direct sunlight.
Specification compliance is dynamic and should only be used as a general guide. Always confirm that the tape you are interested in currently complies with all specification requirements. Please verify that the product number that you select is available in the proper size and color to meet your specification.