Call 800-282-0090


Home > Data Sheet
FILAMNT 4210
4.7mil Uni-Directional Filament Tape



General Information
FILAMNT 4210 is a 4.7 mil, 130# tensile, fiberglass reinforced polypropylene filament tape with a hot melt clear synthetic rubber adhesive. It is a general purpose filament tape used for strapping, bundling, and palletizing.
Backing Adhesive
(unwind)
Thickness
(total)
Liner Type
(outer)
PP - Polypropylene Rubber 4.70 mil  
Adhesion to Steel
180° Peel
Adhesive Activation Tensile Strength Elongation Percent
91.00 oz/in Pressure 130.00 lbs/in 6.00%
Min Application
Temp
Min Service
Temp
Max Short-Term
Temp
Max Long-Term
Temp
40 °F      
Adhesive Tape Features
  • 130# Tensile
  • General Purpose
Adhesive Tape Applications
  • Strapping
  • Bundling
  • Palletizing
Adhesive Tape Markets Served
  • Commercial
  • Industrial
Adhesive Tape Colors
  • Clear
Comparable products
Backing Adhesive Thickness Adhesion
 PP - Polypropylene   Rubber   4.70mil   91.00oz/in 
Backing Adhesive Thickness Adhesion
 PP - Polypropylene   Rubber   5.20mil   84.00oz/in 
Backing Adhesive Thickness Adhesion
 PP - Polypropylene   Rubber   4.20mil   65.00oz/in 

The physical properties listed are typical values and are not to be considered as specifications. Our suggestions for use are based on tests we believe to be reliable. However, the purchaser must carry out their own tests to determine the suitability of the product for their internal use. Information is given in good faith, but without warranty.

It is essential, as with all pressure-sensitive tapes, that the surface to which the tape is applied be clean, dry and free of grease and oil.

Shelf life from date of manufacture is based on the product being stored at 70°F(21°C) / 50% relative humidity out of direct sunlight.

Specification compliance is dynamic and should only be used as a general guide. Always confirm that the tape you are interested in currently complies with all specification requirements. Please verify that the product number that you select is available in the proper size and color to meet your specification.


Choose the surface energy of the exact surface that the adhesive will contact (e.g. if the part was painted metal, paint would be the surface energy).