Call 800-282-0090


Home > Data Sheet
ELE&WH 4190
7 Mil PVC Electrical Insulation Tape



General Information
ELE&WH 4190 is a 7 mil (0.178mm) PVC electrical insulation tape with a natural rubber adhesive. ELE&WH 4190 is used for wire and cable insulation, bundling, and primary splice insulation at no more than 600V. It is non-flame retardant, but UL listed.
Backing Adhesive
(unwind)
Thickness
(total)
Liner Type
(outer)
PVC - Polyvinylchloride Rubber 7.00 mil  
Adhesion to Steel
180° Peel
Adhesive Activation Tensile Strength Elongation Percent
18.00 oz/in Pressure 18.00 lbs/in 200.00%
Min Application
Temp
Min Service
Temp
Max Short-Term
Temp
Max Long-Term
Temp
40 °F   176 °F  
Adhesive Tape Features
  • 7 Mil PVC Electrical Tape
  • Natural Rubber Adhesive
  • 1.5" ID, UL listed core
Adhesive Tape Applications
  • Wire and Cable Insulation
  • Bundling
  • Primary Splice Insulation (No More Than 600V)
Adhesive Tape Markets Served
  • Electronics/Electrical
Adhesive Tape Colors
  • Black
Comparable products
Backing Adhesive Thickness Adhesion
 PVC - Polyvinylchloride   Rubber   7.00mil   18.00oz/in 
Backing Adhesive Thickness Adhesion
 PVC - Polyvinylchloride   Rubber   6.70mil   22.00oz/in 

The physical properties listed are typical values and are not to be considered as specifications. Our suggestions for use are based on tests we believe to be reliable. However, the purchaser must carry out their own tests to determine the suitability of the product for their internal use. Information is given in good faith, but without warranty.

It is essential, as with all pressure-sensitive tapes, that the surface to which the tape is applied be clean, dry and free of grease and oil.

Shelf life from date of manufacture is based on the product being stored at 70°F(21°C) / 50% relative humidity out of direct sunlight.

Specification compliance is dynamic and should only be used as a general guide. Always confirm that the tape you are interested in currently complies with all specification requirements. Please verify that the product number that you select is available in the proper size and color to meet your specification.


Choose the surface energy of the exact surface that the adhesive will contact (e.g. if the part was painted metal, paint would be the surface energy).